Shiny results with the soda-blaster

So, two compressors are in place, and plumbed. They just go into a V and into the main feed to the retractable air-lines. I need to produce a bypass so the air doesn’t go over the oiler. The oiler is nearly empty at the moment so I didn’t worry. However, when it comes to refilling it, then I will need to bypass else I’ll be oiling my soda.

Now, to the pictures. This is the inside of the rocker cover, half cleaned to show the brown lacquer. This has already been through the parts washer to try and get most of the crud off.

Below is the crank cradle – it looks factory fresh but was as skanky as the inside of the rocker cover. Needless to say the entire engine is going to get this treatment inside and out.

2 thoughts on “Shiny results with the soda-blaster

  1. Thanks Rich. The metering valve (basically 2mm hole) helped quite a bit.

    I still didn’t quite have the air-flow I needed but the pot recharged in a few seconds though.

Feed the attention-whore